By Justin To remove the antenna from a Hyundai Tiburon:
- Gather necessary tools.
- Locate the antenna.
- Carefully disconnect and remove the antenna base using specific techniques to avoid damage.
This guide helps with detailed steps for a successful removal.
Gather Necessary Tools
Before removing the antenna from your Hyundai Tiburon, collect the necessary tools to avoid damage to your car. You need a wrench set for the nuts, pliers for stubborn parts, a screwdriver set for any screws, and a flashlight or headlamp for visibility.
Make sure you have these tools ready before starting the removal.
Locate the Antenna
To remove the antenna from your Hyundai Tiburon, first locate it. The antenna's position can change slightly depending on the Tiburon model year.
Usually, the antenna is on the back part of the car, near the trunk. It looks like a long, thin rod sticking up. On older models, it might be on the front or back fender, but it's most commonly near the trunk.
Check around your car to see where the antenna is. If you can't find it, look in your car's manual for a diagram or description.
After finding the antenna, notice how it's attached to your car. It's visible and you can touch it, but it's also connected inside the car. Don't worry about disconnecting it yet; just focus on where it's and how it's attached. This is important for removing it later.
Disconnecting the Antenna
To remove the antenna from your Hyundai Tiburon, first turn off the engine and take out the keys for safety. Wear gloves to protect your hands.
To reach the antenna's base, you may need to open the trunk or access a panel inside your car, depending on your model. The antenna cable is connected at the base and looks like a thick wire.
To disconnect it, press the release tab and gently pull the connector out. If it's hard to remove, check you're pressing the tab correctly and try a gentle wiggle.
Once disconnected, you can proceed with the removal process.
Removing the Antenna Base
To take off the antenna base from your Hyundai Tiburon after detaching the antenna cable, follow these steps:
- Open your car and remove the interior trim or panels near the antenna base. Be careful not to break any parts.
- Find the screws or bolts holding the antenna base. Use the right screwdriver or wrench to remove them. Keep them safe for later use.
- If the base is stuck because of sealant, use a plastic tool to gently pry it off without damaging your car.
- After removing the screws or bolts and dealing with any sealant, the antenna base should come off your Hyundai Tiburon.
Finishing Touches
After removing the antenna base from your Hyundai Tiburon, clean the mounting area well with a gentle cleaner to eliminate any dirt. This is important for a clean seal.
If not adding a new antenna, seal the hole with a weatherproof rubber grommet or plug. For a smoother appearance, consider using automotive body filler to close the hole, sand it, and then paint it to match your car.
Conclusion
You did it! You took off the antenna from your Hyundai Tiburon.
First, you got all the tools you needed.
Next, you found the antenna. You were careful to unplug the antenna without breaking anything.
Taking off the base of the antenna was a little hard, but you did it by being patient.
At the end, you made sure your car looked nice without the antenna.
If you ever want to put a new antenna or put the old one back, just do these steps backwards.
You did a great job on this do-it-yourself project!